Linksys WCG200 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Hardware Linksys WCG200. Linksys WCG200 User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk

Shrnutí obsahu

Strany 1 - Wireless-G Cable

Wireless-G CableGatewayUse this guide to install the following product:WCG200 User Guide

Strany 2

3. Select CD-ROM drive as the only location where Windows will searchfor the driver software and click the Next button.4. Windows will notify you that

Strany 3 - Table of Contents

1. Start up your PC in Windows Millennium. Windows will detect new hard-ware connected to your PC. 2. Insert the Setup CD into your CD-ROM drive.

Strany 4 - Chapter 1: Introduction

1. Start up your PC. Windows will notify you that it has detected new hard-ware. Insert the Setup CD into the CD-ROM drive.2. When the Found New Hard

Strany 5

5. Windows will notify you that it has located the appropriate driver and isready to install it. Click the Next button. 6. When Windows has completed

Strany 6 - Cable Gateway

3. Windows will now search for the driver software. Click the Next button.4. When Windows has completed installing the driver, click Finish.The Wind

Strany 7

2. On the Configuration tab,select the TCP/IP line forthe applicable Ethernetadapter, as shown in Figure4-1. Do not choose aTCP/IP entry whose nameme

Strany 8 - Gateway

4. Select Internet Protocol (TCP/IP), as shown in Figure 4-4, and click theProperties button.5. Select Obtain an IP address automatically, as shown in

Strany 9

4. Select Internet Protocol (TCP/IP), and click the Properties button.5. Select Obtain an IP address automatically. Once the new windowappears, click

Strany 10 - Wireless-G Cable Gateway

29Wireless-G Cable Gateway28The SetupThe first screen that appears is the Setup tab. This tab allows you to change theRouter's general settings.

Strany 11

Basic Wireless SettingsWireless Network. If you want to disable wireless networking, select Disable.Wireless Network Name. Enter the Wireless Network

Strany 12

COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. Linksys is a registered trademark ortrademark of Cisco Systems, Inc. a

Strany 13

33Wireless-G Cable GatewayWireless SecurityWireless SSID Broadcast. When wireless clients survey the local area forwireless networks to associate with

Strany 14

35Wireless-G Cable Gateway128-Bit EncryptionDefault Key. Select which WEP key (1-4) will be used when the Router sendsdata. Make sure the receiving de

Strany 15

the next DTIM with a DTIM Interval value. Its clients hear the beacons andawaken to receive the broadcast and multicast messages.Fragmentation Thresh

Strany 16

39Wireless-G Cable GatewayFirewallWhen you click the Security tab, you will see the Firewall screen (see Figure5-11). This screen contains Filters and

Strany 17

Website BlockingKeyword Blocking. To block a keyword, click Enable. Enter a keyword in theNew Keyword field, then click Add. To remove a keyword from

Strany 18 - Gateway’s Web-based Utility

43Wireless-G Cable GatewaySelect the MAC Address from the list, click the Select button , and click theAdd button. Click the Refresh button if you wan

Strany 19 - Basic Wireless Settings

Port Range ForwardingPort Range. To add a server using Port Range Forwarding, complete the fol-lowing fields:Application. Enter the name of the applic

Strany 20 - 64-Bit Encryption

DMZThe DMZ screen allows one local user to be exposed to the Internet for use ofa special-purpose service such as Internet gaming and videoconferencin

Strany 21 - Wireless Network Access

DiagnosticsThis screen allows you to run a Ping Test to determine if an IP Address isonline.Ping TestPing Target. Enter the IP Address that you want t

Strany 22 - Advanced Wireless Settings

51Wireless-G Cable GatewayAdvancedThe Advanced screen allows you to restore the Router’s configuration to its fac-tory default settings, and to enable

Strany 23 - VPN Passthrough

Table of ContentsChapter 1: Introduction 1The Linksys Cable Gateway 1Features 1An Introduction to LANs and WANs 2IP Addresses 2Network Setup Overview

Strany 24 - Timed Access

53Wireless-G Cable Gateway52Startup Procedure. The status and comments for Acquire DownstreamChannel, Connectivity State, Boot State, and Security are

Strany 25 - Filter Internet Traffic

4. The Cable Link LED will not go solid.• Verify that the coaxial cable is firmly plugged into the Cable Gateway’scable port, with the other end plugg

Strany 26 - Port Range Forwarding

57Wireless-G Cable Gateway56How do I get Half-Life: Team Fortressto work with the Cable Gateway? The defaultclient port for Half-Life is 27005. The c

Strany 27 - Port Triggering

59Wireless-G Cable Gateway58Appendix B: Configuring WirelessSecurity in Windows XPAn acronym for Wired Equivalent Privacy, WEP is an encryption scheme

Strany 28 - Security

2. In the “Control Panel” window, click the Network and InternetConnections icon.3. Click on the Network Connections icon.4. The “Network Connections”

Strany 29 - Information

63Wireless-G Cable Gateway626. When the “Wireless Network Connection Properties” window appears,click the Wireless Networks Tab.7. If the appropriate

Strany 30 - Connect

Appendix C: Installing the TCP/IPProtocolFollow these instructions to install the TCP/IP protocol on one of your PCs onlyafter a network card has been

Strany 31 - Appendix A: Troubleshooting

67Wireless-G Cable Gateway6. Find and double-click TCP/IP in the list to the right (see Figure C-2).7. After a few seconds, the main Network window

Strany 32 - Half-Life: Team Fortress

69Wireless-G Cable Gateway682. In the command prompt, enter ipconfig /all. Then press the Enter key.3. Write down the Physical Address as shown on y

Strany 33 - Security in Windows XP

Appendix E: Glossary10BaseT - An Ethernet standard that uses twisted wire pairs.100BaseTX - IEEE physical layer specification for 100 Mbps over two pa

Strany 34

Chapter 1: IntroductionThe Linksys Wireless-G Cable Gateway is the all-in-one solution for Internet connectivity inyour home. The Cable Modem functio

Strany 35

DHCP (Dynamic Host Configuration Protocol) - A protocol that lets networkadministrators manage centrally and automate the assignment of InternetProtoc

Strany 36 - Protocol

FTP (File Transfer Protocol) - A protocol used to transfer files over a TCP/IPnetwork (Internet, UNIX, etc.). For example, after developing the HTML p

Strany 37 - Ethernet Adapter

LAN (local area network) - A group of computers and associated devices thatshare a common communications line and typically share the resources of asi

Strany 38

SPI (Stateful Packet Inspection) - A firewall technology that monitors the stateof the transaction so that it can verify that the destination of an in

Strany 39 - Appendix E: Glossary

WA N (Wide Area Network)- A communications network that covers a rela-tively large geographic area, consisting of two or more LANs. Broadband com-m

Strany 40

Dimensions: 7.32" x 2.48" x 6.08" (186 mm x 63 mm x 154.5 mm)Unit Weight: 1.5 lb. (0.68 kg)Power: 12VDC, 1ACertifications: DOCSIS 1.1,

Strany 41

85Wireless-G Cable GatewayAppendix G: Warranty InformationLIMITED WARRANTYLinksys warrants to You that, for a period of three years (the “Warranty Per

Strany 42

© Copyright 2003 Linksys, All Rights Reserved.www.linksys.com

Strany 43

Dynamic IP AddressesA dynamic IP address is automatically assigned to a device on the network,such as PCs and print servers. These IP addresses are c

Strany 44

5Chapter 2: Getting to Know theCable GatewayThe Cable Gateway’s ports are located on the back panel of the Cable Gateway,as shown in Figure 2-1.On/Off

Strany 45 - Appendix F: Specifications

76Power Green or red. The Green Power LED is solid when theCable Gateway is powered on. If the LED lights up red,there is an error.Internet - Cable G

Strany 46

9Chapter 3: Connecting the CableGateway You will connect the Cable Gateway to your Cable service’s coaxial cable lineand to the computers in your home

Strany 47

First, make sure that all the devices that you’ll be working with are powereddown, including your PCs and the Cable Gateway.1. Connect the coaxial cab

Komentáře k této Příručce

Žádné komentáře