Linksys EtherFast 10/100 Network In a Box FENSK05 Uživatelský manuál stáhnout pdf (Strana 50)

Setting Up Your EtherFast LAN Card for Wake-

On-LAN Use

1. Use the diagram below to locate the WOL pins and

the jumpers on the EtherFast LAN Card.

2. Connect one end of the 3-pin Wake-On-LAN wire to

the EtherFast LAN Card.

3. Now you need to set the jumpers on your card

according to whether your motherboard supports RWU-

high, RWU-low, or PME. Keep in mind that the jumpers

are numbered backwards: the numbers read right to left

and down to up.

If your motherboard supports Remote Wake-Up High

(RWU-high), set your jumpers like this:

If your motherboard supports Remote Wake-Up Low

(RMU-low), set your jumpers like this:

If your motherboard supports Power Management

Event (PME), set your jumpers like this:

Wake-On-LAN

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 70 71

Žádné komentáře

Linksys EtherFast 10/100 Network In a Box FENSK05 Uživatelský manuál Strana 50